91z28vert's untagged pictures (193)
- Bringing my new '91 Z28 vert home
- Bringing my new '91 Z28 vert home
- Bringing my new '91 Z28 vert home
- Bringing my new '91 Z28 vert home
- Bringing my new '91 Z28 vert home
- Cleaning 'er up
- Cleaning 'er up
- Cleaning 'er up
- Cleaning 'er up
- Cleaning 'er up
- Cleaning 'er up
- Brake job
- Brake job
- Brake job
- Brake job
- Brake job
- Brake job
- Rear Axle
- Rear Axle
- Rear Axle
- Rear Axle
- Rear Axle
- Engine - Cooling system
- Engine - Cooling system
- Engine - Cooling system
- Engine - Cooling system
- Engine - Cooling system
- Engine - Cooling system
Towing from MS on a car hauler.
In the morning at a hotel in LA, still 900 miles to go.
Objects in mirror ARE closer, she was right on our a**! :)
She's looking good in the dark.
But when you turn on the lights, you can see that she will need a lot of attention.
That's what she looks like in the daylight. Needs some body work and new paint for sure. But fir
There must have been a fire in the compartment under the ragtop, the carpet is pretty burned.
Mess in the trunk. Missing spare tire and right plastic cover. The trunk hatch works fine, thoug
Interior has a pretty bad smell, kind of musty and stale. Fortunatelly no mold.
Steaming the carpets because of all the dirt and bad smell. At the same time, I put in new front
Some cover up paint on the front. It looked horrible before. I just used spray paint to hold me
On jackstands, doing a complete brake job (new brakes, new bearings). Also replacing all shocks/
The old brake pads. Worn down to metal. You haven't seen the rotor yet! What a shame.
Old and new brake rotors. The old one is worn down a lot.
New and old brake rotors compared. The inner side of the old rotor is nearly gone. You can imagi
The old and new brake rotors. The old one has many bad grooves cut in it from braking without an
Left rear brake grenaded due to play in axle and brake shoes moving around and sliding off the p
Opened the diff to see how to fix the rear axle in-play (over 3mm) and vibration.
Could not get the pinion shaft locking bolt loose and rounded off the head (in the middle of the
This proves that my rear end gears have 2.73 ratio.
Left axleshaft shim. I just copied the existing C-lock pin.
Had to replace a bent axleshaft because the car was hopping/vibrating at 50+mph.
I pulled the radiator. Nice new piece, looks like it was installer recently.
Damage to the A/C condenser
Close up of the damage. No idea yet whether this is a hole in the condenser lines. There were ma
Dual electric fans. They work but broke off on the bottom.
I fixed the bottom support for the fans and installed them back.
Wiring mess for the fans.
91z28vert